Brake pad/rotor Thickness Limits

[bestia]

Hi

Service limits are:

Pad 1.6mm (0.06 in) not including the backing plate.

Front disc - measure the brake disc thickness at eight points, about 45 degrees apart and 10 mm (3/8 in.) in from the outer edge of the brake disc. Replace the brake disc if the smallest measurement is less than the max. refinishing limit. 26.0 mm (1.02 in)

Rear disc - measure the brake disc thickness at eight points, about 45 degrees apart and 10 mm (3/8 in.) in from the outer edge of the brake disc. Replace the brake disc if the smallest measurement is less than the max. refinishing limit. 7.5 mm (0.30 in)

Steve

Just purchased new front rotors and pads (Honda) and I just want to make a correction to the info above. I checked my rotors with an outside micrometer and they measured 0.984" thick. Minimum Thickness is engraved on the rotor hat and it states 23mm (0.905").