Bought a 2002 CR-V in September 07. Since then, the following has been repaired:
- MIL light on - sensor for emission replaced - MIL light off
- MIL light back on - told needed to replace cannister and wiring harness, Gas tank was removed for procedure. MIL light off.
- Cruise control failed after above repair. Cruise works for 45 minutes, then surges forward and increases RPM. Cruise dash light stays on - Cruise shuts off. Can reset cruise will only work for a few minutes then repeats above problem.
- Engine light back on - told purge joint was needed to be replaced to solve the problem. MIL light off after repair.
- Cruise control repaired with actuator - does not work any better than before repair.
- changed dealers - New dealer replaces cruise control module and discovers hole in gas tank from heat sheild rubbing ( heat shield was bent from the previous repair).
- Cruise still not working after changing both actuator and control module - scared to take it into dealer ( It has already cost a tidy sum to NOT get it repaired $$$$)
Can someone give us some kind of idea what to look for to repair cruise control ???? The cruise seems to work for less than 45 minutes with a/c on - Is this caused by a/c or temperature ????
HelpMeCRV ( will take offers on a slightly used CRV)
