|
|
|
|||||||
| Register | FAQ/How To's | Members List | CR-V|OC Calendar | Honda Club Store | Search | Today's Posts | Mark Forums Read |
| Notices |
 |
|
|
Thread Tools | Display Modes |
11-06-2009, 05:31 PM
|
#1 |
|
crv|oc Rank: Member
Join Date: Nov 2009
Posts: 2
|
torque wrench setting for valve adjustment locknut B20B8 engine
Hi, I'm adjusting the valve lash on our 1999 CR-V and looking for the above torque wrench setting. A few years back I purchased the Chilton manual #30300 for the vehicle which includes this torque wrench setting for the 4 cylinder Odyssey (7 x 0.75mm @ 14 lbf.ft) but I can't see any mention of it for the CR-V. I would say 22 lbf.ft feels about right for the larger B20B8 locknut which has a 9mm thread size. I asked a local mechanic who suggested common sense was sufficient in this instance - "as long as it's tight" was his comment, but it would be interesting to know what the correct specification is nonetheless, if someone has access to it. Thanks.
|
|
|
| Sponsored Links | |
Advertisement |
|
|
11-16-2009, 12:17 AM
|
#2 |
|
crv|oc Rank: Member
Join Date: Nov 2009
Posts: 2
|
Answer
The correct torque wrench setting for the valve adjustment locknut on this B20B8 engine is 18 lbf.ft
|
|
|
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2008 CR-V B16 - which torque wrench should I buy? | SniperD | Maintenance and Service | 11 | 02-15-2009 09:24 AM |
| 2007 Honda CR-V -- Powertrain | T Mac | 2007-2010 Official Specs, Features, Etc. (Gen 3) | 0 | 09-04-2006 07:10 PM |
Linear Mode
