I have been facing issue with error code P0793: Intermediate Shaft Speed Sensor Circuit No Signal
I have replaced TCM and ECM along with engine room wire harness except Engine wire with AT.
When removing Shaft sensor plug then no error appears and gear not shifting , when plugged in above...
I keep getting the engine check light coming on...the diagnostic meter shows mass volume airflow A circuit low....I have replaced the air sensor module but periodicly the check light comes on again sometimes going to limp mode
it does sometimes however clear itself . I have bought a cheap...
Does anyone know what the circuit polarity is for the dome light ? Ford sometimes uses a negative polarity on a number of their vechicles.... So I'm curious as to what the polarity is for the CR-V.
Thanks