Search Results for ‘dashcam’

I just did a hardwire install of a Vantrue N4 dashcam in my 2021 CRV. Here's a link to the unit on Amazon: Vantrue N4. So far, the unit is working well. Installation hiding the wires was actually easier than I expected. I used their hardwire kit, which was also easy to install. With trim...

Hey all, I'm planning on installing a dual dashcam and hardwiring with an inline battery cutoff thing (stop from killing the battery). I was doing some voltage meter checks and I have 2 empty spots with no fuses that show constant on, 1. The tow fuse 2. Moonroof. I don't have either of these...

I just installed my Viofo A129 dashcam purchased from Amazon. Using the Viofo HK3ACC hardwire kit and mini low profile fuse taps For the black ground wire I used a bolt close to the fuse box behind the peddals. For the Battery fuse (red wire that's always on) I used an extra (20) fuse seen...

For some reason, every dashcam I have installed in my 2012 Honda CR-V has exhibited some kind of high-pitched noise. It first started with a mini 0806 and now I'm having the same problem with a new Viofo A129 Duo. Another CR-V owner on dashcamtalk.com mentioned he was having similar problems...

I ran all my wires but now I can't find a place to put the ground wire (drivers side). I looked everywhere, can anyone help? Thanks in advance.

just really curious because i get no straight answer, but more of it leaning to the "yes it is safe and it wont affect your ecu blah blah because it only draws power from it" i wanna hear any experts thoughts on this though. thank you

Howdy! First time poster. And first time owner of a Honda! Bought a new 2018 CRV EXL back in April. Got a Thinkware F770 kit shortly afterwards for it. Spent some time researching how to best connect it and never did find definitive information on where to make the electrical connections. I...

I added a Dashcam recently, a spytec/viofa A119. Nice sleek setup with GPS logging for cheap. Here is where I mounted it. https://imgur.com/a/4V3wd (also attached). Outside the car you would have a hard time spotting it, and it's not obnoxious on the inside either. I did have to mount it low...

After searching for a few days about how to wire the dash cams (especially for rear cam) I find it tricky to work with the side airbag. Here are some conclusions: - The best practice is to open the A pillar trim, wire along with the existing cables using zip ties. If it goes outside into the...

Hi guys. Looking at getting dashcam fitted professionally. I know its easy but Id rather get it done properly with wires hidden. Just wondering if anyone else has hardwired their own dashcam and any bad effects of hiding the wiring such as loose panels etc. BTW the camera Im going to get...

I don't normally post things like this, but I want to save you all some time. I was in the market for a dashcam, and if you are too, you'll soon find out that there are overwhelming number of options out there. After deciding on which to buy, I soon found that the wedge camera I bought was...

Does anyone have a recommendation for a good dash cam that offers front and back monitoring? I've been looking at the Garmin models, primarily because I trust the brand. The KDLinks also looks really good, but I don't think either company offers a model with front and back monitoring. Perhaps...

Decided to finally put dashcams on both my vehicles. I bought the best rated one for a low price according to dashcamtalk. I have it setup so basically starts recording whenever the vehicle is turned on and stops recording once the vehicle is off. It keeps recording on 32gb sd card and...