dtc

Manufacturer Communication on NHTSA site dated Apr. 25, 2019. Applies to '17 and '18 CRVs. Service Bulletin - The shift position indicator ("D" light) starts flashing due to DTC P2817, (Shift solenoid valve O/P [pressure control solenoid H] stuck off) being set. When the TCM checks the drive...

I am hoping that someone can help with a problem which is driving me crazy!:wall: - Apologies, I posted this originally in the wrong group and could not move it. :Darn: Recently the ABS and VSA lights came on, on my wife’s 2010 CR-V i-DTEC. I pulled the code using the paperclip between pins 4...

I am hoping that someone can help with a problem which is driving me crazy!:wall: Recently the ABS and VSA lights came on, on my wife’s 2010 CR-V i-DTEC. I pulled the code using the paperclip between pins 4 & 9 on the OBD2 connector and it came back with DTC code 17 “Left-rear wheel sensor...

I have been facing issue with error code P0793: Intermediate Shaft Speed Sensor Circuit No Signal I have replaced TCM and ECM along with engine room wire harness except Engine wire with AT. When removing Shaft sensor plug then no error appears and gear not shifting , when plugged in above...

I had issues a few months back with my instrument cluster (2008 CR-V) that sounded all too familiar when I began reading forum posts from others - flickering lights, intermittent gauge 'dropouts', flickering center graphics display and/or 'confused' graphic display showing just jibberish - so...

My 2003 CRV-EX has just displayed the CEL/DTC P1456. It is supposed to be in the Evaporative Control System somewhere. It is not a loose fuel cap as one of the suggested possibilities. I am not sure where besides the one under the hood the others are located. A Google search only shows various...

Hi guys, what would be the best value for money code reader for trouble shooting? My car is a 2009 I ctdi CRV Thank you Sent from my iPhone using Tapatalk

It was transferred to me from child to parent. Needed a smog certification but the Check Engine Light was on. So took it to a transmission shop where I was told: "Slow take off starting 2.0 mdma; 2 wd r+r 788.00; takes off in 3rd gear, scan P0700 trans fault; system contaminated, fault...

Hello all, the CEL went on yesterday, and my OBD scanner gave me the code P1078 - intake manifold runner control system (high RPM) malfunction. I searched this forum not no satisfactory answer. I consulted the shop repair manual to check the IMRC connections, which seemed fine. I even began to...

I'm still having problems with my 2000 CRV transmission. After driving a short distance the engine revs but the car does not move in any gear. After turning off the engine for a short time, restarting the car will drive again for a shorter distance...... The service manual says to plug in the...

I just bought on friday. Now dtc o2sensor(p0139)&evap(p0157). The place i bought it from did inspection. What should i do? Take it somewhere else and get it inspected. To show the dealership it failed and have them fix it? I am thinking about taking it to honda and having them look it over. Is...

Hi everyone Have got an abs fault dtc codes 15 and 17 have looked them up seems to be wheel senser and ignition voltage Could anyone please tell me the location of the abs control unit to locate the 26 pin plug so I can measure the sensors and check the voltage as per the fault guide. Thank you

MIL plus DTC P1077 = replace the IMT (IMRC) solenoid valve. Fairly simple job: one electrical connection and two vaccum lines and one bolt. The IMT (IMRC) solenoid valve had to be ordered and was fairly expensive $151. The TSB is no longer available online but the CRVs affected are all 2004 and...

I have a 2003 CRV EX 4wd auto I am getting DTC codes of P1298 and P1457 at the same time. It originally occurred in the Morning after being parked all night. I did some snooping around and did a visual inspection of all the hoses and valves on the Evap unit with no obvious problems noted. I...

Hello, I have a 2002 CR-V (LX 2wd). SRS light came on. I have the service manual and used the special SCS connector to try and get the dtc code (i.e. count the blinks). But there was no stored code. In other words the light stayed on steady and according to the service manual this is "normal"...

I have purchased (2) pre-owned CR-V's this year, the first for my girlfriend and then one for me, as I enjoyed driving her's so much :) I just had the OBD run as my engine light came on this morning. It appears to be the O2 sensor, no big deal. My bigger concern is that the odometer reading...

I have a 2001 CRV. The other day it threw up the "Check Engine" lite. The code showed. "O2 senser low voltage, Bank 1, sensor1". I replaced the upstream O2 sensor, and cleared the code. The check engine lite came on again in about 1/2 mile. Showing the same code. I have cleared it 3 times, but...

I have a trouble code on my 02 CRV. P0661. IMRC voltage. I've researched this forum and found some old stuff but never got a resolution. I brought the car to the dealer today.There first step is to erase the code and test the system to see if the code returns. I have a code reader and have done...

I have a 2002 CRV with 60k miles that has the check engine light on with a DTC of P1457. I have replaced the “fuel vent module” and “vent shut valve” clearing the code after each repair. But each time after one day of driving the check engine light comes back on with the same P1457 code. Any...

what is it and how to repair it ?