Honda CR-V Owners Club Forums banner
egr
1-12 of 26 Results
  1. Diesel CR-V
    Hi everyone As my DPF is finally gone, I'm going to have it removed and I'm considering EGR, DPF delete with Stage 1 remapping. I'm a little worried about how much power the auto gearbox can reliably handle though. I've found a few comments on clutch reliability here after remaps but nothing...
  2. Performance Modifications
    2005 CRV 2.0 I want to blank off my EGR, just like I did in my previous cars. The cars ran very good with this mod. World of difference. But, some other cars on the market may get a warninglight coming on, when disconnecting. Blanking off with a thin steel plate works. BUT, if the EGR works...
  3. Gen 4: 2012-2016 (UK 2012-2017) CR-V
    Hello all I have a 2013 CRV diesel that needs an intake manifold and egr clean. Is there a decent ‘how to’ guide out there? Thanks
  4. Diesel CR-V
    Just bought a used 2015 CRC 1.6 diesel from Evans Halshaw. Within a day of purchase the car went into limp mode on the motorway (on a family trip to Scotland!). I took it to the closest Evans Halshaw in Glasgow who diagnosed a faulty MAS sensor and blocked EGR. They cleaned out the EGR but...
  5. Gen 5: 2017-2022 (UK 2018-2023) CR-V
    I was doing the 3rd oil change over the weekend and noticed a couple of new leaks collecting on the engine bottom pan. One appears to be slow fuel-like from the left side (relative to driver's seat position). The other is on the right side toward the back of the engine where two vertical EGR...
  6. Diesel CR-V
    As per title. Where is the EGR valve located? Thanks
  7. Accessories
    I emailed the company asking them if that had any pictures of a Superguard installed on a 2013 CR-V or a vehicle similar to it. They basically said that they emailed the company headquarters in Australia to see if they had any pictures. I would like to see the look of it before pulling the...
  8. Gen 5: 2017-2022 (UK 2018-2023) CR-V
    Has anyone considered installing an oil catch can in the EGR line? Reading about the pitfalls of direct injection (as in my 2017 CRV with the 1.5L engine), I am concerned that without port injection that the intake valve will form carbon deposits resulting in later issues (cold start misfires...
  9. Diesel CR-V
    Hi, my engine's not happy from just below 2,000 rm to about 2,800. I suspect the EGR valve but even my local garage couldn't shift the bolts to remove and clean it. The price of a new EGR valve is ludicrous; that is never going to happen... It's a vacuum triggered valve, not solenoid operated...
  10. Gen 3: 2007-2011 (UK 2008-2012) CR-V
    Error code 2413 says EGR valve error causing misfire. Had it at the dealer and they cleaned the egr valve and was good for 6 months. Now same error code so I removed and cleaned it but error still present after clearing codes 3x. I was going to put a new one in $300 Cdn from dealer but they say...
  11. Dear Honda:
    Hi all, I have a 2005 CR-V 2.2 CDTI and whilst on holiday pulling a caravan I had a large cloud of black smoke and car went into limp mode, I connected the OBD and it came up with egr valve fault, I re set the code and everything was ok except now it kicks out a load of smoke on hard...
  12. Performance Modifications
    I have a 2003 CRV, Does anyone know what the 3/4" vacuum line is that connects from the valve cover to the airbox is? The nipple that is part of the upper airbox has been broken since i bought the car. I've tried epoxy to weld it back together, but it always ends up breaking. I would just...
1-12 of 26 Results
Top