Honda CR-V Owners Club Forums banner

exhaust

  1. 1999 severed exhaust pipe

    Problems & Issues
    I have a severed exhaust pipe, just a little in back of the centerline of the front tires, right before what I think is the catalytic converter. Unfortunately I dont have a photo now but the sever is also next to what appears to be a flex or ribbed pipe. I think I might be able to fix it with...
  2. black soot in both exhaust

    2017 - Present Official Specs, Features, Etc. (Gen
    Sorry if this has been covered but could not find a thread about it. I have a 2018 touring, owned a little over 2 months, with 2100 miles on it. I see that both exhaust tips have a lot of black soot (film) . CRV runs great, no problems at all. Gets about 31 MPG all around use. I only use top...
  3. Exhaust dollar bill test

    Problems & Issues
    I've recently purchased a 2007 2.0 Petrol CRV. 71,500 miles. I was reading up on service intervals for valve clearance check and adjustments which the manual says is every 25,000 miles. It's had main dealer services but I have no proof that the valve clearances have been checked or adjusted...
  4. 2006 Exhaust Fumes when stopped

    Problems & Issues
    Hello, I've done the search. I smell exhaust fumes in the cabin when stopped and idling. I don't smell it when moving. I can't find a leak in the exhaust system. I even did a smoke test. Are there any common issues know to the CR-V? Thanks, Stan
  5. Exhaust Fumes in car CRV 2011 2.2 D-DEC

    Recalls, TSB's and Notices
    I am experiencing Exhaust fumes in the car interior , have been advised by local Honda dealer " that it may be a fault with the EGR cooling pipe" does anyone know if there is a recall or TSB for this problem as i have come across several other instances of this fault.
  6. Chrome Exhaust Tip

    Accessories
    Looking for chrome exhaust tip that covers most if not all of the oem exhaust. Must be large enough to fit over the standard pipe. Would prefer it to run up to/near muffler. 2018 1.5 Turobo.
  7. FS First Generation Honda CRV OEM Exhaust Pipe Finisher Stainless Steel !!

    Trading Post
    Nearly impossible to find now, an OEM Honda stainless steel exhaust finisher for the first generation Honda CRV (1997-2001). Original owner, just removed (so used condition). Original bolt should be replaced with a new stainless bolt (I'll do it if i have time). Approximately 4.5 inches in...
  8. Replace Angled Exhaust Pipe Ends

    Under The Hood / Performance
    What effect on performance would occur if the down turned exhaust pipe ends where cut off and replaced with some sort of straight pipe ends?
  9. 2018 CRV EXL Exhaust Pipe Outlet

    Problems & Issues
    I hope to dress up our 2018's exhaust pipes look with paying the high price genuine Honda pipe outlet and installation. Some of the after market outlets require a different rear bottom panel. Any information regarding the modified panel? What exhaust outlet do you use? This first photo shows...
  10. Exhaust pipes

    2017 - Present Official Specs, Features, Etc. (Gen
    I purchased a 2018 EXL model in July. Never took a look at the exhaust pipes till today. Yes, yes I know my bad. The exhaust pipes look welded piece by piece and rusted already? Should I be concerned?
  11. Gen 5 Exhaust ?

    2017 - Present Official Specs, Features, Etc. (Gen
    Does the 2.4L Gen 5 CR-V have one or two mufflers? Thanks.
  12. 97 CRV bogs down with acceleration and then dies

    Maintenance and Service
    Hello, I have been struggling with this CRV all day. It randomly started today out of the blue, when I was driving it, it just started to bog down as I was accelerating and would barely accelerate, and then it just died. I have been searching and searching for answers and have tried a few things...
  13. Lift Exhaust?

    1999-2001 Official Specs, Features, Etc. (Gen 1.5)
    Hi there, my name is Sebastian, I am from Germany and I recently purchased a 2000 Gen1.5 CRV with 140k on it. We used to own a Gen 1 a few years back in New Zealand and when we saw this one, got a bit nostalgic and gave it a go. I am currently thinking about getting OME springs for lift, or...
  14. Dual exhaust for 2.4l

    2012-2016 Official Specs, Features, Etc. (Gen 4)
    Does anyone know of a good aftermarket dual exhaust for this model. Thanks in advance
  15. Blue smoke from exhaust

    2017 - Present Official Specs, Features, Etc. (Gen
    After 5 secs or so from starting the car I just completed slowly backing out from the garage and about to move forward when I noticed blue smoke in my headlights. I had driven the car a few hours earlier so it wasn't sitting for a long period of time. I frequently smell rich exhaust odors if...
  16. RD1 Honda CR-V Mugen Twin Loop Exhaust

    Trading Post
    I'm selling a used Mugen Twin Loop Exhaust. It's for the 97-01 Honda CR-V. I'm the original owner and have the original documentation from Kingmotorsports. I'm asking $700. I prefer local pick up because shipping will be a pain. Location: Bronx NY
  17. CR-V exhaust or intake

    2017 - Present Official Specs, Features, Etc. (Gen
    Has anyone put a louder exhaust or an intake on their 1.5 crv? IK its a crv so dont start saying that its just an average crossover. I am just curious.
  18. One exhaust manifold - twin exhaust in the rear?

    Under The Hood / Performance
    Pondering my new '18 EX I realized that in the back are twin exhausts. I popped the hood and in the mass of plumbing and unfamiliar (made my Passat V6 look sensible!) parts I couldn't spot the manifold or exhaust to the back. I'm ready to be embarrassed with the obvious answer if someone could...
  19. Exhaust Finisher

    Exterior
    I saw this on Amazon & eBay and for $38 for a pair thought I would give it a shot. I think it looks really good and fits great. The screw post are all most all the way in when tightened so all you can really see is the small nuts. I'm curious to see how long they will last before they start...
  20. 2008 Exhaust camshaft lobe galling

    Problems & Issues
    I did some searching but didn't see anything dealing with the generation 2008 is in. Have galling on the #1 exhaust camshaft lobe when I did my first valve lash adjustment since I bout it 2 years ago as it was getting a little noisy at startup. I have been doing oil changes with 5W30 full...
Top