Honda CR-V Owners Club Forums banner
intermediate
1-5 of 8 Results
  1. Gen 5: 2017-2022 (UK 2018-2023) CR-V
    I have been facing issue with error code P0793: Intermediate Shaft Speed Sensor Circuit No Signal I have replaced TCM and ECM along with engine room wire harness except Engine wire with AT. When removing Shaft sensor plug then no error appears and gear not shifting , when plugged in above...
  2. Tires, Wheels, & Suspensions
    Hi, 2010 CR-V and I am trying to remove the intermediate shaft and bearing carrier to replace the transmission axle seal. I cannot figure out how to get the 3 bolts off the bearing carrier. Can't seem to reach the top bolt, at least with the tools I have. Has anyone done it? I assume that I...
  3. Gen 4: 2012-2016 (UK 2012-2017) CR-V
    My Honda dealer says that I have a badly leaking intermediate shaft on my 2013 CR-V. They removed a plate on the bottom of the car and showed me the shaft which appeard to have a light film of oil and dirt on it. Couldn't see any other signs of heavy leaking and the transmission fluid level is...
  4. Gen 1: 1996-2001 (UK 1995-2001) CR-V
    hello im new to this and im trying to get help on how to replace intermediate shaft bearing. I'm replacing my axles on my 98 crv and the half shaft bearing are worn out and im having a hard time finding the part. Also new to doing diy fixes on my crv and learning about cars to save some money...
  5. Dear Honda:
    Dear Helpful Honda. I have a 2012 Honda CRV EXL + Navi 2WD and last 3 years I visited Honda dealerships more than 7 times for the problem. Vehicle has currently approximately 25K miles and Honda part # 44500-T0A-A00 was replaced under warranty 3 times. There is still oil leak from passenger...
1-5 of 8 Results
Top