Honda CR-V Owners Club Forums banner

pin

  1. 2015 CR-V SE asking for a pin after 2nd battery swap

    2012-2016 Official Specs, Features, Etc. (Gen 4)
    Hello y'all! I've recently changed out the battery for my 2015 CR-V SE (For you guys wondering what the hell SE is, I'm pretty sure it's a just special edition for Canada, in between LX and EX) for the 2nd time, and the infotainment screen is asking for a pin. Now I've already searched the...
  2. Balancer Shaft sprocket pin dowel or woodruff key?

    Under The Hood / Performance
    Has anyone removed the balancer shaft sprocket in a 2004, 2.4L K24A engine? If so, was there a woodruff key of any kind to keep the sprocket in place? I just removed mine and there is a gap in the sprocket and in the shaft that could house one, but I didn't find it. I have not seen one in any...
  3. new to forum, need to locate 13 pin plug to illuminate sill LED's

    Greetings & Introductions
    Hi I have a Black Edition UK (white) 2.2Idtec. the only mods are...Mapped to 210hp by Celtic remaps UK, mainly for towing caravan and we always run on mobil1. When i get to grips with the forums I am looking for some help locating a 13 pin plug to enable LED door sills. We cant seem to find...
  4. Pin Stripe or other????

    Exterior
    Hi. I am the owner of a 2016 Honda CR-V AWD that I bought at salvage auction with 670 miles on it last year. It had been totaled due to all over damage (scratches and dents) as well as needing an entire front clip. Looked to have gone in a wooded ditch or something. The air bags had never gone...
  5. Pin Stripe On Cladding

    Exterior
    Can pin stripe tape be put on the lower cladding? I’m considering putting a single stripe near the top. Your suggestions and comments please.
  6. New Honda Push Pin Tool?

    Maintenance and Service
    The older plastic push pins usually have slots at the edge that allow the low dollar push pin tools to easily grip them. (Harbor Freight etc.) The newer style pins do not have the slots and some of the older style tools do not work well. Honda has released a new style push pin puller for the...
  7. 2008 CR-V EX-L Navi OEM Head Unit Connector Pin Outs

    Mobile Electronics
    Hello, New member here... Searched the forum and the web but can't seem to find what I am looking for... Sorry if this is a repeat thread! Does anyone have the pinouts for the rear panel connectors on the OEM Alpine CD/Radio/Navi head unit for the 2008 CR-V EX-L Navi? In particular, I'm...
  8. Anybody have the Pin Out For The Auto Dimming Interior rear view Mirror

    2017 - Present Official Specs, Features, Etc. (Gen
    Hi Guys/Gals Believe it or not the version of CR-V sold in the Caribbean only comes with a Manual Mirror! So I have purchased a used self dimming mirror. To my surprise the mirror has a 7 pin connector, I thought this mirror only used a 12V supply and everything else was done internally. I...
  9. 2008 CRV Rear Brake slide pin question

    Problems & Issues
    I have a 2008 CRV and have a question about the rear brake caliper slide pins. Does the completely round pin go on top or does the pin with the flat side go on the top. I am going to do my brakes soon and have gotten different answers on what is the correct pin goes where. Thanks for any help.
  10. Ignition Key Will Not Turn, Ignition Module Punch Pin Locations ?

    Problems & Issues
    My daughter's 2005 CRV's ignition key won't turn to any position other than off (key is not stuck in ignition). I've removed the ignition module but I can't find where the punch pins are located. I believe there are two pins but I only found one. Can anyone tell me where the pins are located on...
  11. Help please. Grounded PIN 16 of OBD-2 Connector. 2005 EX. How bad is it?

    Problems & Issues
    Hi All, First time post on this forum. I have searched around a bit but couldn't find what I need. Hope someone can help. I have a 2005 EX with 4AT. The SRS light came on a few days ago. I is acting differently than when the car had a bad switch in the seat belt connector. When the car...
  12. Need Help with Caliper Sliding Pin Grease

    Maintenance and Service
    Is there a grease that won't swell the rubber seals on the sliding pins that I can use?
  13. Honda Factory fog light switch pin out?

    Do-It-Yourself / Mods
    Hi.. guys. I just installed fog light kit. (got it from ebay) but on/off switch does not fit well. So I want to swap it with Honda factory switch (I have a Honda Fit switch). It seems there are more wires on factory switch than ebay kit switch. Anybody know which wire goes with which wire...
  14. OBD disconnection for security, which pin?

    Mobile Electronics
    Hello, Considering that some thieves are able to connect to OBD port and steal the car by generating new virtual kyes, I am thinking to disconnect the OBD port and re-connect when needed. Probably will use a simple switch. Here is the OBD2 pinout info: My question: is it enough to install a...
  15. front caliper mounting pins, pin B

    Maintenance and Service
    I am changing the front pads and rotors on my 2010 CRV LX. I removed the pins that the calipers attach to that are in the caliper mounting bracket. I attempted to reinstall the pins after greasing them, but the pin B with the rubber collar on the bottom continues to push out, possibly due to...
  16. 1999 Driver Door Issue: Won't Lock or Unlock Without Manually Pushing Down the Pin

    Problems & Issues
    I have a 1999 Cr-V and currently the driver door cannot be locked or unlocked manually using the key. (I don't have a key fob.) Inside the car the automatic lock system works on all other doors except the driver door. However, I can manually push and pull the indicator pin up and down to lock...
  17. Caliper guide pin lube?

    Maintenance and Service
    What lube do you use on your caliper guide pins?
  18. How to connect 4 pin flat connector to 6 pin CRV trailer connector

    Racks, Hitches and Towing
    Hi all, I have a 2000 CRV and want to wire in a 4 pin flat connector for a small utility trailer. I live in Costa Rica and don't have ready access to the store bought cable harnesses. I'd like to directly wire in the 4 pin connector wires to the appropriate wires in the 6 pin Honda trailer...
  19. '06 EX AWD: Need help pin pointing vibration

    Problems & Issues
    Hello all, my name is Andy Statland, from Severn, MD. I have a strong back ground in rock crawling vehicle fabrication including suspension and roll cage work. Ironically, I have never really done more than typical maintainence on my and my wife's daily driven cars other than oil changes and...
  20. Stereo Mute Pin? 02 standard stereo

    CR-V Owners in Europe
    Was wondering if there is a pin on the rear of the standard radio/cd player (single din) that when earthed mutes the sound on a 2002 CR-V? It's to integrate a bluetooth handsfree kit (not a Honda one). Can't find any info on this at all, so any help appreciated.
Top