Search Results for ‘removing’

delete thread please

Hi there, I just purchased my first new to me Honda CRV - she's a 99 engine is sound, and well cared for - about 274k miles on her. So far the only thing I am having an issue figuring out is why when I turn it off there is a series of 3 beeps (I'm still in the car - the door is just open...

Long story short while sitting in back seat my wife dumped an entire pumpkin pie onto my armrest and a bunch of it got inside the rear heat/ac vent. I'd like to take it apart to clean it thoroughly. Does anyone have instructions or tricks to getting the trim apart without breaking any of the...

How do I remove the front armrests?

I would like to remove the orange plastic tip from the dipstick in order to make it easier to read. It is nearly impossible to see the level when the oil is fresh since it almost seems to "climb" up the tip even with the dipstick held down or horizontal. Of course the new oil is transparent...

Removed badges Has anyone removed most (cannot remove H front and back) badges from your CRV? What is your opinion of such a clean look?

I am considering removing excess oil through the dipstick channel using a syringe and 1/4" tubing. My concern is that the tubing gets stuck and cannot be removed. Has anyone done this successfully? Any tips would be appreciated. Thanks.

Our brand new 2019 CRV Touring was sold to us with dealer installed door edge guards and I want them off. The salesman told us the guards are glued on and a lot of time and labor is required to take the off. Looking for guidance on how to remove the guards without damaging the doors and...

Didnt want to bump an ancient threads, ive seen a few on here for first gens and one for 2nd gens like mine saying you could remove the driveshaft and drive the vehicle. Just not 100% sure if the shaft is needed to turn an oil pump or clutch pack etc since i dont really know what all that...

Recently purchased a used 2017 CR-V EXL with the Honda moon-roof visor already installed. I'm interested in removing the visor as it reduces the size of the moon-roof, makes a horrible flapping noise when crossing long bridges on windy days and makes the roof hard to clean. I found the...

I have a 2009 crv. I’m curious about if I am able to remove the bottom cushion of the back seat to possibly make the seat lie flat. I’m not interested in removing the whole seat, simply removing the cushion if at all possible. Anyone done it?

I have replacement passenger seat that I want to swap into my 2003 CRV, can someone tell me the best way to remove the plastic trim coving the bolts. I looked at it a bit and can't quite figure out how to remove the left front bolt cover. I don't want to break it if there is a trick to it.

If I pull off the warning stickers from the sun visors inside the car, does it ruin or leave a mark on the visors? Thank you. Has anyone done this? Sent from my SM-G950U using Tapatalk

So I started the process to remove the back seats of my 1999 CRV model. So far I have the bottom part of the seat off but what to get the rest off. I was wondering if there is anyone out there that has taken the seats off completely and if they could give me some insight on how to do that (What...

Anyone know of a good video showing the steps to removing the blower motor on a 2007 - 2011 CRV? i've googled like crazy and can find nothing on that generation CRV.

i watched a couple youtube videos on the 2017, but it seems that even though the 2018 is supposed to be very similar to the 2017, the "undercover" on our 2018 EX-L is not a metal plate held on by screws. i admittedly haven't looked at it carefully, but it wasn't clear to me what needs to be...

We have a problem with our 2008 CRV, mice got in and set up shop somewhere behind the dash. The mice have been gone for a couple months but they didn't take their stench with them. I'm looking for a way to pull the dash to remove the nest completely. Our local competent body shop really...