Search Results for ‘repair’

Hello everyone, I am working on solving a few of my engine problems and next on the list is an oil leak. I traced it down to where the head meets the block, so I suspect the gasket is leaking externally. I am trying to figure out if it is leaking internally as well. Here are some of the things I...

I assume I need to remove the hatchback inner plastic panel but I can't figure out how to get it off. I found the screw in the back door assist handle and removed that but nothing seems to be able to pop off easily. I have searched for hours for videos showing how to do this but I can't find any.

hello, I have a 2005 Honda CRV and a few months ago the VSA light and the little triangle light with an exclamation mark and the check engine light came on randomly. I was driving on the freeway and my car started bucking because the VSA light and triangle/exclamation mark light and check...

Hello Everyone does your car retractable mirrors do not work?? Well here is the fix which is the most common problem on crvs. This is a detailed guide of diagnose and fix of retracting mirrors so please take your time to read through this post. First of all we need to make sure what is the...

Hello, I am new to this forum, if I posted this in the wrong place I apologize and do not know much about vehicle repair. My wife drives a 2013 CRV that is paid off in full and was running great until last week. She got off work and tried to drive and her steering wheel was very hard to turn...

My 2006 CRV's moon roof will slide back with no problem. However the option for the back part to tilt up isn't working. Of course this is the option I use the most. We have tried resetting it, but that didn't work. Any ideas?

Hi, Just got my CR-V II back from the shop after a periodic control, and I need some advice. First off; I need to overhaul the brakes. I need to change both the brake pads and discs on all four wheels. There is too much rust on them to call them safe, and I think exchanging everything would...

Hello all, I've got a 2003 LX AWD Automatic and I'm in Canada. The other day I was out shopping and when I started the car back up I accidentally shifted past drive into 2nd gear (2 as displayed on the selector), and I'm now physically unable to move the shifter back up into drive, or neutral or...

The ball joints that are used throughout 02-06 CRV’s are a great, lasting OEM design. They are not known for common failures. The joint is a “B-type” ball joint style (has a large letter B on the top side), that is not offered by Honda Genuine unless it is a part of the entire steering knuckle...

I unfortunately backed into a concrete pole and need to replace my rear bumper. If I purchased a 2005 rear bumper off a car in a junkyard, would it fit? Looking for any help to keep costs down on a silly mistake. Thanks in advance!

Hi, I am the proud owner of a 2003 CR-V, 2.0 i-VTEC. Recently, my right rear wheel got really hot. Turns out the parking brake had locked up, but only on one side. Long story short, I have now checked the wires, and taken off everything but the drum. When I was about to pull off the drum, it...

Hi Last Friday my problem suddenly started. I turn the key, the engine cranks but won't start. RPM are zero but go up just a little bit from time to time as it would like to start. I can hear the fuel pump starting. I sprayed starter spay on the throttle, doesn't help. Spark plugs a bit worn...

I have a 2002 Honda CRV LX with less than 110,000 miles. The check engine light has come on and a Low Catalytic Efficiency code was read off of the engine. I live in Golden Colorado so I have to pass emissions test, also I am a broke chemical engineering student so I don't have the cash to drop...

So I’ve seen a few posts about door locks, but none that have the same problem as me. So my key fob has never worked so I always used my key. Normally if I unlock my car with the key, it unlocks the drivers side and I can unlock the others with the switch. And when I’d lock the drivers side with...

I have a 2012 with 120K miles on it. Honda dealer was replacing the front wheel bearings and said that when they were pressing in the new bearing the front knuckle bent. They said it happened because it was very rusty. My wife doesn't think we should have to pay for the part since it wasn't...

This Friday I'm taking her in to have the notorious "heater core" repair? Is there anything I should watch out for or prepare for regarding the dealer? This is suppose to be covered by the HondaCare warranty. Sent from my SM-N960U using Tapatalk