replacement

Does anybody have any instructions for replacing the front and rear bumper garnish? We've got the replacement garnishes but are unsure how to remove the current ones and fit the new ones! It's a 2016 model. We have been told it's an easy job but thought it best to check before we started...

Hello FYI, Bought extended warranty when I bought my used 2013 CRV at 60K. Used it twice for repairs. Not covered were brakes and rotors. Had driveshaft and right rear wheel bearing replaced. Went to do rotors etc. and found bottom caliper mounting bolt to be stripped as well as the mount on...

Hi all, First-time poster here. I cracked the housing on my passenger side view mirror backing out of the garage. The skull cap and the lower part of the housing are chipped; mirror motor still works fine. I've found the appropriate parts from HondaPartsNow.com (entered my VIN, so I know...

Hi folks Currently online I see the 2nd gen solenoid removal. The 3rd gen has a deflector on top. Does anyone have the instructions to remove the solenoid. The deflector and the wiring harness with the bolt torque is what I am trying to find. Sent from my iPhone using Tapatalk

the battery on my 2016 CRV seems not to be retaining charge very well anymore and probably needs replacing. Is there any reason this can't be done outside of the dealer? Do they need to reset anything after the battery is changed? Will I lose any internal settings after the battery in...

I have found a bunch of different products on ebay that go over top of the wood trim accents on the CR-V, is there anyone that has actually installed these here? How is the fit? I saw someone had vinyl wrapped theirs which I would like to do but I don't really want to remove the door panels on a...

Hi, Can anyone tell how to sefly remove ABS sensor? Thanks

I live in South Florida and need to replace the tires on my 2013 CRV-EX, FWD, with 20,500 miles? Would appreciate any recommendations!

Dear Gentlemen Hope that the solution i need can be found here with the help of the amazing guys in this club I have a problem that seems no solution in the web nor in YouTube or i'm just bad at searching Vehicle - CRV 2002, 2WD Auto, Left Hand Drive Issue - I have a broken Handbrake Lever...

The glove box door on my '19 has a big, nasty scuff and I would like to replace it. Is this a difficult job, requiring a lot of dash dis-assembly, or can a competent DIYer do it themself ? I've scoured the 'Net looking for instructions but have had no luck finding anything. Thanks.

Hello all, I've owned my 02 AWD manual trans for about 3 years now and have had no major problems. It has ~ 160,000 miles and I just noticed that the driver's side front CV axle boot busted open pretty significantly and has shot out a significant amount of grease. I'm going to replace both axles...

My V is has 90k miles and has developed a vibration at highway speeds under throttle. The dealership is telling me that both front axles are bad. Is this common? What causes them to fail. I’m under warranty, but how much would this job typically cost? Thanks

I'll have owned my Honda CR-V for 7 years in a few months. She's in for an oil change/tire rotation today but they told me I would need to get spark plugs at 7 years (it's 7 years or 100,000k miles the dealer said and she's at about 50k miles this fall). I try to be good about maintenance and...

Hello I am researching on how to remove and replace a propeller shaft for the 2012 CRV Touring. The bearings are going on mine and it is making a whining/grinding sound when in motion. So I am likely going to buy a DORMAN replacement driveshaft. I have access to a garage to lift the vehicle...

Hi, just a quickie. I’m going to swap out my fuel filter on my 2001 petrol auto. (Very high chance it’s clogged and a new one will only do good) just wanted to double check that the system doesn’t need a bleed afterwards. I know diesels require it, but can’t find anything on petrol engines...

Does replacement of the differential insulator #16 in the attached diagram require a shop press? I am wondering because the part seems to have a metal sleeve like a control arm bushing. Thanks

Anyone had to replace the heater hose in the 2008 honda crv ? Is this a steel line or an actual hose ? What is the price to replace if leaking fluid ? Thank you in advance for the replies Tsgrass

When I had the windshield replaced in my '97 many years ago, the replacement had one of those ugly blue tints on the top few inches to reduce glare. Ugly. Reminds me of an old GM. Thanks to our Michigan roads, I got hit by another big stone, and now the windshield on my '09 is cracking...

Hi all. I've had my 11 CRV for a couple years now. Just getting to replace the rear wiper blade. However, the replacement I bought from a local auto store doesn't fit. Anyone had this problem? Don't prefer to buy simple parts like this from the dealer. Any help is appreciated. Steve

How difficult is it to set sensors in windshield to the factory setting when having windshield replaced by glass repair company