Search Results for ‘valve’

Dear all, According to this site, Maintenance Sub Items Number 3, 4 & 5 are: 3 - Replace ATF fluid 4 - Replace Spark Plugs, inspect water pump, and inspect valve clearance 5 - Replace engine coolant Does anyone know exactly what (e.g. certain miles, conditions, etc.) would really trigger these...

Hello all, ran into a issue while changing my plugs today. Cylinder 3 has oil all over it, and the coil is covered in oil. I know that mean I need a new valve cover gasket. Any how, I picked up the gasket, and now need help deciding on putting the right RTV sealant on. I picked up permatex ultra...

I've got 144,000 on my 2012 EX-L and the valves are getting louder. Does anyone have instructions on how to adjust the valves? I couldn't find anything in the forums. Thanks

I had clear the code ran fine for a few minutes dropped down to 1200 RPMs then it started surging any other ideals, :confused2:

I wonder if anyone uses an oil drain valve instead of the supplied plug. I tried to get this on Ebay but it is deemed incompatible. Ebay item # 283097334669 F106N Quick Oil Drain Valve M14-1.5 Threads with Nipple I did check that the dia of the oil drain plug are 14mm. Is there a tried and...

how long can you typically go till it starts ruining valves and burning them on the valve adjustment. my '06 said check and adjust if necessary at 11000. I checked mine at 100000 and they were tighter than spec, but not completely tight with no slack. i'm in the market for another crv, and...

Several videos on youtube exist regarding a product (CRC intake valve and turbo cleaner) that some are using to mitigate possible valve corrosion and costly cleaning down the road due to the direct injection system. I’m wondering what people’s thoughts are regarding this as a preventative...

I have had my (new to me) 2012 a couple of weeks now. All good (except the heater core) and was wondering if the valves need adjustment at some point on this generation. I am coming from a 2001 which did need such attention.

Hello, my 2008 honda crv EXL, 106k miles, is producing a tapping sound from the engine especially when in drive mode. My mechanic diagnosed it, checked the engine oil, and is suggesting that we first try with the following: 1. Replace Valve cover gasket 2. Replace 4 iridium spark plugs. I don't...

Sadly my daughter got rear ended in our 99 Crv that was supposed to last her all through high school and college but it was totaled. So we found her an 02 that seems to run and drive great with 160K miles on it. I noticed today it was 2 quarts low on oil with 3K miles remaining before the next...

Hi experts I think about saving some money by not following strictly the service schedule about valve adjustment. Will there be any symtoms when driving my 2010 CR-V indicating that valve adjustment is needed? That is, what will happen if/when valve adjustment gets out of specifications? Is...

We all know of the defective Heads of the First Gen engines. The Seats pound themselves into the Head so that instead of there being excessive Gap on the Rockers they actually close up. OK, did an adjustment the other day only to find that one of the #3 Exhaust valves cannot be gapped properly...

When the time comes I want to replace the coolant myself. However, I alsomwant to purge the system of unwanted air. Where is the cooling system bleeder valve located? Thanks......

I need to replace the black plastic piece (actuator valve) of the turbo assembly ( part# 18900-5PA-A01) on my 2018 crv. I can't find the piece by itself, and getting the whole turbo assembly will set me back $1k. Since some civics share the same assembly (despite different tuning), would it make...

Daughters AC got really weak on her 99 V. Everything under the hood checked out. Compressor running, condenser fan running. So I opened the cabin air filter compartment. One tube evaporator coil was ice cold and frosty. The other warm. So I New I wasn’t getting cold gas through the evaporator...

got this thing a few weeks ago, it's mint. 98000 on it, original owner, and dealer maintained. reading that even though there's no ticking, that the exhaust valves may become tight and cause damage. thinking i'll ride this out through winter and adjust them next year in the spring. did a few...

Hi Everyone I have a issue my Ck gas cap has been on for a couple of years Yesterday the engine light came on I stopped by my friends shop The scan came up with 2 codes P0497 and P145C low purge flow He was able to clear that with his scanner I have to wait and see if it comes back on Anyway...

Hi all, It may sound a daft question, but I have searched high and low for the inlet and outlet valve clearnce settings for the above vehicle to no avail - even asked the stealerships, but as usual they are tight lipped. If anyone knows the settings I would be grateful for the info as it is...