Honda CR-V Owners Club Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
Does anyone know the trade numbers for the 2 sizes of miniature lamps used on an '02 LX's HVAC control panel? The lamps themselves do not appear to be removable from the holders, I am looking to replace all 6 with LED lamps, please note that I am seeking the trade numbers (T-1, NEO3, etc) and NOT the Honda part numbers.

I've attached pictures of both lamps.

Thanks !
 

Attachments

· Registered
2005 and 2006 EX AWD
Joined
·
360 Posts

· Registered
Joined
·
31 Posts
Discussion Starter · #3 ·
Thanks Dave for your response, however the reason why I want to get away from using halogen lamps is evident in the lampholders. As you can see, there is minor scorching on both holders, additionally the lamps have "fused" themselves to the holders, this is why I want to use LED's.
I've already changed out certain lamps in the instrument cluster with LED's without any issues of dimming.
 

· Registered
2005 and 2006 EX AWD
Joined
·
360 Posts
I saw that on my 2 crvs also these LEDs would work if they dont light just turn 180 degrees + - but may need to solder to existing fine wire,the LED leads might fit through the holes if not solder, just stick with the 12v because adding a resistor will be impossible on the holder,I have found on LEDs if you take some sand paper and sand the end of it they will not be as directional and spread the light out the sides better,I found that on back lighting on my ham radios never did it in cars because of dimming issue ,looking at the reviews people have used these on Honda and others for HVAC and dash so these look good the one with the Odyssey the grey base they just soldered directly to the board and discarded the holder I guess https://www.amazon.com/Partsam-Emit...=1564955645&s=gateway&sr=8-15#customerReviews
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top