Honda CR-V Owners Club Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
36 Posts
Loose electrical connectors. Pull the bulbs out and use a small screwdriver to bend the connectors a bit; so they're a tighter fit. do the same to the main wiring harness connectors. The heat and current draw over the past 15 years, waddled out the electrical connectors. You may want to get a tube of dielectric grease to squeeze into the connectors, to prevent moisture and corrosion damage.
By the way; Your bulbs (H1) are interchangeable. If you loose a bulb on the road; you can just swap them over - until you can get a replacement.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top