Honda CR-V Owners Club Forums banner
1 - 4 of 12 Posts

· Registered
Joined
·
342 Posts
Discussion Starter · #1 ·
Noticed the car would idle a bit low then come back up to regular idle. Hoses are ridiculously hidden. I unbolted the IAC and with teh hose attached just sprayed some Carb cleaner thru the Screened hole (intake side) and the other hole ( output side). It made it worse. Has anyone had success taking it off and pulling that bottom plate and cleaning it better? I have always cleaned these on my other cars without issue. What the heck is the Idle Intake Thermo Valve? has anyone needed to clean that?
 
  • Like
Reactions: shadyv

· Registered
Joined
·
342 Posts
Discussion Starter · #3 ·
The air passage? From where to where? I still suspect the IAC since It did get worse after spraying. When I get off the gas, the idle drops way down and then slowly finds it's way close to 500rpm
 

· Registered
Joined
·
342 Posts
Discussion Starter · #6 ·
I get it... I just don't know where it is on my '99. honestly, in 190K miles I have not had to play much other then Timing Belt changes, and Trani and Rear End fluid changes.
Thanks for the THERMO VALVE definition.
 

· Registered
Joined
·
342 Posts
Discussion Starter · #8 ·
AIR PASSAGES... Are you talking about some that may be in the Throttle Body Throat? OR?
You mentioned an Air Passage Screw, where is that? It's doing OK, only real issue is that I am out of Valve adjustment on one exhaust valve , Cylinder 3
 
1 - 4 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top