Honda CR-V Owners Club Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
hi. I need to know if anyone has a good link for a clean install on the, 1'st-gen-v's?

Information for:

Removing tabs near doors, to route wires under carpet. Finding firewire to lead wires to battery. Unexpected, problems during install ect?
 

·
Registered
Joined
·
4 Posts
I did a clean install last week with basic knowledge on which dash panel to remove.

You need to find that link which I forgot, then it's all easy to remove/replace dash in place for installation.

On my side, I routed 8ga live wire from battery through the fender then behind the dash to next to PCM then through passenger's door plastic trim on the floor to the behind.

Every other wire go from radio through the same place to the behind.

All the installation is pretty neat and works perfectly. I used the rear floor "holder" (black metal part bolted to the trunk floor) for the ground of the amp.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top