Honda CR-V Owners Club Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
So I recently bought a crv after my car was wrote off I have a vss senor code not a big problem , and a abs light but my e brake light will not go off I fondled with the e brake and slammed it up and down to see if it’ll go out and no luck , checked the fluid all is good any ideas e brake cable is cut on one side due to apparently the rear sub frame being replaced
 

·
Registered
Joined
·
3,934 Posts
I think it is the brake fluid level sensor in the brake fluid reservoir... Check that out on Google, etc.
Here is one of several youtube vids available:
Buffalo4
 

·
Registered
Joined
·
6 Posts
Discussion Starter #4
Well I know the cable for the abs is cut from the wheel bearing but I can’t see a intake code causing that , side not high beams don’t work either and obv the drls don’t either but I changed a bulb and still same thing
 
1 - 4 of 4 Posts
Top