Honda CR-V Owners Club Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter #1
SO... I am attempting to replace my lower ball joint boots (both sides are torn). Plenty of grease in both and no noise so I am moving forward with it. (Especially since a new ball joint requires the entire knuckle)

EITHER WAY: Please do not make this about why I should just replace the ball joint. I know the benefits... I just want to do the boot. That being said.

I am to the boot but I cannot for the life of me figure out how to get the boot off the ball joint. I have the new boot I just need the old one off. Any help with that would be GREAT!
 

·
Registered
Joined
·
47 Posts
Discussion Starter #3
but there is some type of ring in the rubber that keeps it on and I cannot get it off. Not like the rings on the outside that hold them on and come off with a tool.
 

·
Registered
Joined
·
1 Posts
Lower ball joint boot replacement

Could you tell me if you were successful in replacing the boots and if so, what brand you used? I have the same problem. The boots are torn, but the joints are fine, and I don't want to replace the steering knuckles. Any info would be greatly appreciated. Thanks
 
1 - 9 of 9 Posts
Top