Honda CR-V Owners Club Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
246 Posts
Discussion Starter #1
Drivers window does not work. No motor noise at all. 3 other windows work fine from master. I will check the switch but that was already replaced one. Most likely motor.


Does not look like Honda just sells the motor. Whole regulator with motor, $350-$500 for just part.

Rock Auto sells just the motor for $45.

Have any of you guys just replaced the motor. Did it work out?

Thanks
 

·
Moderator
Joined
·
1,947 Posts
I would first run jumper wires straight from 12v power to the motor to see if it works. If it does, look for corrosion in connecters or at the ground connections, then try bypassing the switch. If the motor works but none of this solves it, there is a further troubleshooting section in the service manual involving testing in-dash modules and such. If motor does not work, you are SOL.

https://www.hondapartsnow.com/genuine/honda~regulator~assy~72250-s9a-a03.html
 
1 - 3 of 3 Posts
Top