Honda CR-V Owners Club Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Dear forum,
While replacing my rear shocks, the cable to the rear wheel sensor got snagged and pulled out of the back of the sensor. I replaced the sensor with another but cannot seem to reset the ecu/lights.

I have tried with an OBD2 scanner which does not show any faults, I have disconnected the battery for over an hour and I have reset the SRS using the jumper wire.

I have searched this forum and used google extensively and see lots of post for early crv's and other honda's but nothing that matches or works for me.

The sensor was replaced with a 'bilstein', very reputable brand so I'm not expecting this to present any issues either.

There's lots of mention of the ABS connector to short, where might I be able to find this on a mk3?

Many thanks in advance.
 

·
Registered
Joined
·
2,551 Posts
I think you may have to get the tire shop or the dealer to get into the computer and log the serial number of the sensor into your cars computer system. Since it doesn't recognize the sensor it will cause the lights to light up.
 
1 - 2 of 2 Posts
Top