Honda CR-V Owners Club Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
Decided to make my own spacers out of some Delrin I found at work. It's 5/8ths Delrin which should really give me about a 3/4 inch rear lift. I also purchased some new 50mm long M10x1.25 Grade 10.9 bolts and a 70mm hole saw from Amazon for $10. So far have about $15 into this.

What I will do to prevent water from getting in is smother the flat upper surface with a t hick coating of transmission silicone gasket maker.

Planning on installing the rear struts in a few weeks. Once I have enough to purchase the front and do them all at the same time.


135384
135385
 
1 - 1 of 1 Posts
About this Discussion
0 Replies
1 Participant
atxjax
Honda CR-V Owners Club Forums
Honda CR-V Owners Club forum, the best hang-out to discuss CVT, Hybrids, trim levels and all things CR-V
Full Forum Listing
Top