[Longgonedave]

Where can I find this pressure switch on a 2011 CR -V. D light is blinking and that was the code I pulled.TIA

 

[Dave J]

Where can I find this pressure switch on a 2011 CR -V. D light is blinking and that was the code I pulled.TIA

here's some info PDF, what code is it? looks like A is a common one to go bad , I see now dont confuse solenoid A and switch A different part but remove the air cleaner and it should be there if you unplug it, it should throw a circuit code to verify its the correct one

 

[Longgonedave]

P 0847 (02)

 

[Dave J]

looks like 3rd clutch switch B is the problem P0847 3rd Clutch Transmission Fluid Pressure Switch Circuit/Stuck On - Automatic Transmission

Possible Causes	Setting Conditions
3rd clutch fluid pressure switch circuit is shorted to ground Update the PCM to the latest software 3rd clutch pressure switch connector is damaged (check pins for damage) 3rd clutch pressure switch has failed (it may be stuck on)

 

[Longgonedave]

Thanks!

 

[Dave J]

looks like a blue wire with white stripe on 3rd clutch switch B in the diagram they are calling it A but A is the 2nd clutch switch I think, good luck man, also make sure the fluid level is good,not over or under

 

[Dave J]

ok found the procedure its on the bottom check the pins on the connector also

 

[Longgonedave]

Yahoo! Thanks.