Honda CR-V Owners Club Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
can anyone tell me what the inside diameters are for these lines? i'm planning to install some inline filters for both systems on the return side. i can't really get an accurate measurement unless i were to take lines loose entailing some labor...albeit minor. just figured if someone knew it'd be easy. thanks!!!
 

·
Registered
Joined
·
136 Posts
I was wanting to do to same thing, but ended up having to just rebuild my tranny instead.

If your car has been sitting, you should be able to disconnect the tranny cooling hoses at the transmission end without losing any fluid. You could then measure the hoses or pipes easily enough.

If you're going to go as far as putting an extra filter in, I've seen a lot of recommendations to get a separate transmission oil cooler, rather than reconnecting it to the engine radiator.
 
1 - 2 of 2 Posts
Top