Did you check to make sure you're not out of gas? Easy to do in to excitement of working on your new car.
99 CRV stalled out after valve lash adjustment. Help!
Hi I just bought a 99 CRV with 125k. It had codes p1399 p0300 p0301 p0302. I changed the plugs, wires, dis cap/rotor, and did a valve adjustment to spec. Also changed out valve cover gasket. I turned it on, all check engine lights went off, idled great, and drove great. After about a couple miles I had power loss until it completely turned off. Everything works and it cranks but I can't get it to turn on. Any ideas?
1 - 5 of 5 Posts
No codes or error lights? Normal lights ?
Sure you tightened the nuts on the adjusters? Guessing the gaps changed because of lose jamnuts
Another thought.. Did you tighten the screw on the rotor? All wires pushed into the Cap? See if they walked up off the Cap
1 - 5 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CR-V Owners Club Forums
Honda CR-V Owners Club forum, the best hang-out to discuss CVT, Hybrids, trim levels and all things CR-V
Full Forum Listing
Top Contributors this Month
View All
EXcommunicated
152 Replies
williamsji
112 Replies
SVTfocusO3
94 Replies
Recommended Communities
