Honda CR-V Owners Club Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter · #1 ·
I vaguely remember a post that notes what direction to turn the adjustment screw, but I couldn't find it. I want to lower them a bit? So, which direction lowers them - clockwise/counterclockwise ? ... Thanks!

Sent from my SM-N960U using Tapatalk
 

·
Everything in Moderation
2006 CR-V EX, 5MT
Joined
·
13,522 Posts
Note the lighting pattern against a wall (use some masking tape if that helps) and just turn the screw until the beam cut-off goes lower. If you have the room, the results will be most accurate at a distance of about two car lengths.
 

·
Registered
Joined
·
15 Posts
Note the lighting pattern against a wall (use some masking tape if that helps) and just turn the screw until the beam cut-off goes lower. If you have the room, the results will be most accurate at a distance of about two car lengths.
Good tip!

Find the room at a shopping plaza. Go to the side or back of the stores where employees park.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top