[motil]

I did this last week (sorry no pictures).

Remove the plastic trim from the rear hood. I have cut away the old camera. Placed the new camera and ran the wiring through the rubber at the hinges on the left side. I wanted to avoid getting stuck at the glass roof so I ran the wiring down to the doorsteps and plastic panel near the seatbelt (remove the doorrubber and there is a easy acces). Below the dash there is enough room to get it through. this part speaks for itself

The only problem I ran into is that I can't get any image on my headunit (pioneer camera and avic F9770bt headunit). Reversing positive and negative doesn't work. I can only get a black screen when I put it in reverse.

Hope you have better luck!

 

[motil]

I don't know about that. i already had an OEM system before replacing. I'm sure you are better of with a aftermarket system. They are far cheaper and more up to date than the original

 

[motil]

I have to come back to you on that. I tapped in on the original wiring for the + and groundwire. I ran all three wires from the boot to the headunit. It does trigger when I change to reverse but still no visuals on my screen. The supplier thinks the camera is broke. I have to remove everything and send it back When I have the time I will, but it will not be this weekend.