Honda CR-V Owners Club Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Bought 2 pairs of the plain off the shelf black rubber door edge guards from Autozone but I was unable to install them because the door lips on the 4th generation are too thick due to what I think is bead of seam caulk on the inside of the lip. The size of the opening of the guard was not wide enough to allow it slide on. Hate to spend money for the OEM ones. Always use the off the shelf stuff and never had an issue until this car. Wondered if anyone knew of any aftermarket rubber door edge guard that has a wider gap to accommodate the thicker edge of the doors on the 4th Gen CRV. I see many different ones on Amazon but there is no way to really tell the gap size.

Adam
 
1 - 2 of 2 Posts
Top