Blinking Compass

Gregavi said:

Hi, My wife and I just purchased a used 2013 CR-V for our 16 YO daughter. On the main screen the compass Calibrate (Cal) is blinking. The manual explains how to calibrate it but when I push and hold the setup button, the screen goes to "Clock Setup". No matter how long I hold down the setup button, it stays in the Clock setup menu. How do I get to the Calibration/Zone menu?
Thanks in advance.

Click to expand...

From member's another post...

OK, here is the fix. There is a small control module that is bad and located under the rear headliner and near the antenna base. Honda part # (78300-T0A-A01). Cost is around $45-50 depending on what your dealer is willing to discount. To replace just remove the rear drivers side trim plate that is next to the headliner and then the dome light cover and the two bolts and then carefully pull down the headliner to expose the small module. The module is attached with a plastic plug on one side and a 10mm bolt on the connector side. Not a super easy job but not that difficult. There is a youtube video online that is for replacing a damaged antenna base that shows the steps to get the headliner lowered.