Honda CR-V Owners Club Forums banner

Break Away Switch Install 2014 CRV

1700 Views 3 Replies 4 Participants Last post by  416764
Hi Everyone,
I need to install a break away switch on my CRV so that I can legally flat two my 2014 CRV behind a motor home.

The question I have is where I can easily run the wire from the front of the car through the firewall and into the driver's side compartment.

Has anyone done this that can give me some advice on the best location to use to get the wire through the firewall?

Thanks in advance,

ED
Status
Not open for further replies.
1 - 1 of 1 Posts

· Registered
2010 EX-L (AWD, non-Nav)
Joined
·
565 Posts
Find a rubber grommet (preferably unused) and poke a hole in it. Failing that, find a rubber seal through which some wires go. Poke a hole in it.

Once the wire is fully in place, seal up the hole with silicone glue.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top