Honda CR-V Owners Club Forums banner

1 - 6 of 6 Posts

·
Registered
2007 Honda CRV 2.2 I-ctdi EX AWD
Joined
·
27 Posts
Discussion Starter #1 (Edited)
Hi all, my CRV 2.2 diesel had its crankshaft pulley replaced just before I bought it, the new pulley has the old original bolt holding it on, should this of been reused?
 

·
Registered
2007 Honda CRV 2.2 I-ctdi EX AWD
Joined
·
27 Posts
Discussion Starter #2
And also should there be any movement? The pulley is wobbling side to side while it's spinning
 

·
Registered
Joined
·
94 Posts
I suggest you take it back to the shop that the car got the work done and tell them to fix it. There should be no wobbling with the pulley whatsoever. The mechanic probably misaligned and/or did not torque the bolt down enough. As for reusing the bolt, as long as it still in good condition, it should be good to reuse, however, since you are bringing back to the shop, have them replace with new one. And double check their work again prior to driving off.
 

·
Registered
Joined
·
592 Posts
I know some Toyota engines the bolt is recommended to be changed if removed

Why did they change the pulley the first time?
 

·
Registered
2007 Honda CRV 2.2 I-ctdi EX AWD
Joined
·
27 Posts
Discussion Starter #5
Ok thanks, first one got changed due to noise/vibration, I didn't think the wobbling was right
 
1 - 6 of 6 Posts
Top