Honda CR-V Owners Club Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I am trying to replace the front wheel bearings, and the axle spindle will not come out of the hub and bearing assembly. I'm going to buy a new steering knuckle and hub assembly, and was wondering if there's a difference between the 2WD and AWD knuckles? All I seem to find for sale online are 2WD knuckles.

Thanks.
 

·
Registered
Joined
·
2,856 Posts
I don't know the answer, but out of curiosity why are you doing this on a '13? Was it a premature failure or something?


Sent from AutoGuide.com Free App
 

·
Registered
Joined
·
571 Posts
use a brass punch and a hammer, or a zip gun if you have. If its still jammed place a hammer on the spindle and have some hit it with a sledge hammer.
 

·
Registered
Joined
·
1,098 Posts
Does this help?

I am trying to replace the front wheel bearings, and the axle spindle will not come out of the hub and bearing assembly. I'm going to buy a new steering knuckle and hub assembly, and was wondering if there's a difference between the 2WD and AWD knuckles? All I seem to find for sale online are 2WD knuckles. Thanks.
Part numbers for 2WD and AWD Knuckles are the same; however, Right and Left wheel bearings are not. The right side has an inner bearing on the half shaft.

Here is the diagram: http://www.hondapartsnow.com/parts-list/2013-honda-cr-v-5dr_ex_awd-ka-5at/driveshaft-half-shaft.html

Here is the wheel bearing diagram: http://www.hondapartsnow.com/parts-list/2013-honda-cr-v-5dr_ex_awd-ka-5at/front-brake.html
 
1 - 9 of 9 Posts
Top