[Dannynica]

Thank you for sharing the pics!!

i am thinking to change mine too, on my 2005 CRV

i bought it from honda, just ready to install it


thanks

 

[Dannynica]

No problem. Glad if they helped.

Sal, how did you got that clamp out???

i was looking at mine, and the clamp is facing down, and i cant not even fit my fingers in that area

What you used to get the clamp out???

 

[Dannynica]

Ahhhh ok, thank you. I will see if I dont break my nails doing that. Lol

 

[Dannynica]

You need these pliers to get at that clamp. Still doesn't make it easy but sure helps.

http://www.harborfreight.com/hand-tools/pliers/11-inch-long-reach-needlenose-pliers-with-45-offset-jaws-39537.html

Actually i thought about that,

I just got me a 90 degrees angles plyers similar to that one, i will try it because with my fingers alone could not do it

 

[Dannynica]

I WANT TO CONCLUDE WITH MY WORK DONE ON THIS:

I removed the PCV on my 2005, It is needed a 90 degrees bent plier. The clamp is facing down so that plier make it easier, then just pulled the hose and removed the valve with a 17mm deep socket.

I did not replaced because the valve is still good, just gave it a spray cleaning just to make sure

 

[Dannynica]

Yeap, on my 2005 CRV is torqued to 33lbs. My manual shows that too