Honda CR-V Owners Club Forums banner
1 - 1 of 1 Posts

14 Posts
Discussion Starter · #1 ·
Hi All

Just had a kenwood ddx371 installed in our 2011 cr-v with a metra installation kit and i`m not happy with the angle of the unit in relation to the surround and also noticed there is a small gap below the heater controls now as if its not pushed home fully (due to the install kit). The installers said that its because of the installation kit but I wanted to check whether someone else has done the same without this problem.


See right hand side of the unit in relation to the surround.
View attachment 27601
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.