Honda CR-V Owners Club Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi, new person here from Wales.
I was hoping that somebody could help me with my CRV power seat problem. It's a 2008 model that I just picked up.

It slides forwards and backwards perfectly well and also tilts from the front absolutely fine.

What is not fine is that the recline feature doesn't work, the seat doesn't go up or down and the lumbar support does not work.

I checked the fuse and that appears to be ok but after that I am lost.


Any help or guidance would be much appreciated. Thanks in advance, Mike
 

·
Registered
Joined
·
772 Posts
Mike, a big welcome to the forum from Georgia USA. As for the seat, like OP stated maybe a connection problem. If it were myself, I would unbolt seat in order to lay it backwards to get to underside. There should be a master wiring to unplug for access. Good luck and jump in often.
David g.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #4
Thanks for the responses:+1:
I'm concerned about setting off any airbags, so are there any wires I should avoid? Thank you.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
I'm a little terrified of the airbag going off! Anything I should avoid? Thanks for the replies. :+1:
 
1 - 6 of 6 Posts
Top