Honda CR-V Owners Club Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
281 Posts
Discussion Starter #1
I bought a set of LED reverse lights and was wondering the trick to change em out? I removed the two obvious screws but was not sure if there is a trick to pull out the tail lights? Thanks
 

·
Registered
Joined
·
294 Posts
Page 575 of the manual:
1. Remove the lower taillight assembly.
2 Brake/Taillight, Rear Turn Signal Light and Rear Side Marker Lights P. 574
2. Remove the cover by prying on the edge
using a flat-tip screwdriver.
u Wrap the flat-tip screwdriver with a cloth
to prevent scratches.
3. Turn the socket to the left and remove it.
Remove the old bulb.
4. Insert a new bulb.
Taillight: LED
Back-Up Light: 16W
1Taillight and Back-Up Lights
Taillights are LED type. Have an authorized Honda
dealer inspect and replace the light assembly.
 

·
Registered
Joined
·
281 Posts
Discussion Starter #3
kinda vague. Is there any more details like where to pry?

Page 575 of the manual:
1. Remove the lower taillight assembly.
2 Brake/Taillight, Rear Turn Signal Light and Rear Side Marker Lights P. 574
2. Remove the cover by prying on the edge
using a flat-tip screwdriver.
u Wrap the flat-tip screwdriver with a cloth
to prevent scratches.
3. Turn the socket to the left and remove it.
Remove the old bulb.
4. Insert a new bulb.
Taillight: LED
Back-Up Light: 16W
1Taillight and Back-Up Lights
Taillights are LED type. Have an authorized Honda
dealer inspect and replace the light assembly.
 

·
Registered
Joined
·
27 Posts
I was washing my crv today and noticed the right rear tail light assembly is loose. Anyone have any experience with this? I don't see any obvious way to tighten this up.
 

·
Registered
Joined
·
8 Posts
2013 CR-V Turn signal wiring

I installed led lights on my outside mirrors. Where can I connect under the desk for left and right turn signals? Wire color, tie in etc.
Thank you
 

·
Registered
Joined
·
56 Posts
I used two plastic pry tools to remove the cover and replace the reverse lights. One went in the small opening where are pry tool can go. I used a second one to slowly work around the cover. I bought a set of tools from amazon that was recommended here on the forums but was thinking after the fact that some plastic bike tire levers would work.
 
1 - 8 of 8 Posts
Top