Honda CR-V Owners Club Forums banner
1 - 4 of 4 Posts

Registered
Joined
1 Posts
Discussion Starter · #1 ·
I am trying to replace the knock sensor on my 2016 CRV. Does anyone know where I should look for it on my engine? I chekced some YouTube videos and they were not helpful (always a dated model).
Thanks
 

Registered
17 CRV EXL AWD, 14 CRV EXL AWD
Joined
2,567 Posts
On the 2014 it's on lower front of the engine block. Just to the right of the coolant thermostat housing. But from the 2016 diagram (part #14) it looks like its on the back of the engine block. In either case you are going to have to remove the splash shield. Have fun!

BTW the 2014 and 2016 use the same knock sensor so the torque spec is 16 lbf-ft.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top