Honda CR-V Owners Club Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a 2008 CRV (base 2WD model). I was backing up and bump into a small post, it was just a light bump but the fender poped loose, there was no physical damage that I can see but I can't push it back in.
Is there any instructions to show how to remove the bumputer so I can set the fender back into its place?
Thanks
 

·
Registered
Joined
·
772 Posts
Click on above link, page 5, item 14/15 will get the cover off. If there's any indention damage to the bumper, use a hair dryer, not to close, you can get it warm and push from behind (it will burn you) with a hammer handle. BTW, welcome to the forum, good luck.
David g.
 
1 - 3 of 3 Posts
Top