Honda CR-V Owners Club Forums banner
  • Hey everyone! Enter your ride HERE to be a part of December's Ride of the Month Challenge!
1 - 3 of 3 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
Good evening all, I recently ordered a replacement rear driveshaft for my 2000 crv. When I ordered the part I had ordered it "with hardware" which should have included the mounting bolts. They did not ship the bolts. Does anyone know if o'reillys or autozone would carry anything comparable? I read the size is M10 x 1.25?, Here are pics of what I am looking at, also I am not sure if the the holes in the last pic take different sized bolts or not?

I did find these available at autozone, would these work?-
https://m.autozone.com/nuts-bolts-a...-m10-1-25-x-25mm-flange-bolt-3-piece/848436_0




Thanks all

Wheel Auto part Bumper
 

·
Registered
Joined
·
155 Posts
Are you talking about the bolts that hold the shaft to the dif and trans?

Those are sorta funky.

What happened to the old ones? Re.use them if you can.

Try going to a true value or ace hardware. They have a good section of metric bolts.

The stock bolts are 12 point, w.a flange on them. If I remember right, the head on the. Is smaller than it should be...based on the size of the threads....in this case, 10mm, you didnt list the length. 1.25 is the thread pitch (fine).
 
1 - 3 of 3 Posts
Top