Honda CR-V Owners Club Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I need to replace my third high brake light on my 2013 CRV.
It appears I need to access if from the tailgate by first removing a piece of trim and then disconnecting the bulb and unscrewing the mount.
The process seems easy enough, but I'm concerned about how to best remove the trim without causing any damage.

Here is what we are looking at:
136749


136750


136751


I need to remove the panel shown in the top picture. If I put moderate pressure pulling where the red arrows are I can hear and feel each side click out a little. Not enough that I think those sides are fully engaged, but enough that I believe I'm disengaging the fasteners at least partly.

I can't seem to disengage it fully however and I don't want to force it without knowing the proper way.

There are small indentations in the metal where the blue arrows are. They seem to be there to allow a hand to get inside to apply pressure - but once again I don't just want to yank it off without knowing the proper way.

According to this replacement guide:


It looks like there are 4 fasteners and indeed 2 are near the ends and 2 near the indentations.
Do I just grab and pull? Do I pull the outer sides first or the middle?

Are the fasteners something that will need to be replaced or are they meant for removal?
Any assistance/guidance much appreciated.
 

·
Registered
2016 CRV Touring AWD
Joined
·
4,063 Posts
You almost had the answer! So close!!!

Honda has a spoiler you can add. College Hills did a video "how to" install.

Now go to your local parts store/ harbor freight etc and get the trim tool you need to remove the paneling.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top