Honda CR-V Owners Club Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 5 of 5 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
just swap:ped out the 98 manifold for a skunk2 not hard at all took about 45 min check it out also put hondata gasket car flows much better hear r some pics
 

Attachments

·
Registered
Joined
·
13 Posts
Hows the low end feel? Im stuck between doing a ls intake or waiting to see if my buddy sells me his skunk 2. Everyone seems to be going k series around here so im getting parts for cheap.
 

·
Registered
Joined
·
2 Posts
skunk2 intake manifold and skunk2 tb

I recently put a skunk2 im and tb at 70mm. I did notice a difference but not as much as i had hoped. Mainly in the mid to high end.
It also seems to have improved it slightly in the low end as well.

Ive been told the most noticeable gains are seen when you get a chipped and base mapped ecu. To do that though you need to convert to an OBD1.
Does anyone have any info on doing that.
Should i use a p28 ecu or a pr4. I dont know a whole lot about the ecu side of things.
Any help would be appreciated.
 
1 - 5 of 5 Posts
Top