Honda CR-V Owners Club Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hey guys,

I'm planning to raise my 2002 CRV with HDPE strut spacers. I work in plastics manufacturing and have a sheet of 20mm HDPE. I was planning to use a router to cut 2 spacers for each strut and either weld or use adhesive to stack 2 together to get a 40mm spacer.

However, since my CRV is my daily driver, I don't really have time to pop out a strut, measure it myself, reassemble everything, then drive to work to have them cut, then go back home and remove my struts again.

So I'm wondering if anyone has a Gen 2 strut spacer template or dimensions I can use?

Cheers.
 
1 - 1 of 1 Posts
Top