Honda CR-V Owners Club Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Is their any one that have rebuild their 2.2 dci CRV diesel engine? Can the sleeves be replaced or do you have to buy a new block? And why does Honda SA say that the sleeves are chromed plated and the sleeves can't be replaced?

Engine number N22B31007497


Please help with advise!

Regards

Frans Reichert
 

·
Registered
Joined
·
112 Posts
I don't know,but I think I have seen a video where they say that the sleeves are welded into the block,I think that this may be
true as you say the sleeves are chromed on the inside,this would give a much harder surface and would reduce wear and
probably increase slip in the cylinder.
 

·
Registered
Joined
·
112 Posts
The video was for a cheap head gasket replacement on a Honda civic with the same 2.2 petrol engine not the diesel,but think nearly everything the same only no plug holes and things on the diesel.
 

·
Super Moderator
'07 CR-V EX-L AWD
Joined
·
4,600 Posts
This post is several years old and the OP never came back after that time, so I doubt the conversation is going anywhere.
 
1 - 4 of 4 Posts
Top