Honda CR-V Owners Club Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
I have a problem with the drivers window not fully closing,the glass goes up and down ok but before it reaches the top of the door and it's about 5mm short it stops and starts clicking..I am thinking it's a problem with the regulator and hope the motor is ok..Any thoughts please
 

·
Registered
Joined
·
1,646 Posts
Mine did that. The regulator started to bend outward from the motor gear and pushed itself off the gear. Looking at the regulator, the top few teeth actually look cut in half so they are only half wide now. I bent the regulator gear closer to the motor and bent the little tab on the back side tight as well and it has been holding up for about 3 years now. I just try and be careful when I close it so I don't finish stripping out the gears.
 

·
Registered
Joined
·
19 Posts
Discussion Starter #3
All sorted.The teeth on the regulator were worn so i have replaced it with a new one,now operates as it should.
 
1 - 3 of 3 Posts
Top