Honda CR-V Owners Club Forums banner
1 - 8 of 8 Posts

·
Registered
2018 CR-V Touring
Joined
·
51 Posts
I bought several pieces from Amazon, the vendor was "Flash2ning", and I've been happy with the fit and color match. I mostly did it because without them, I'm looking at black switches surrounded by more black. The wood breaks it up, makes the many switches stand out more.
 

·
Registered
2018 CR-V Touring
Joined
·
51 Posts
It sticks on top. Thin enough that it does not end up elevated relative to the surroundings. They give you swabs of "adhesion enhancer" that I felt were too aggressive, would actually etch the surface. I used alcohol swabs instead, and everything adhered nicely. I did what shows in the picture up top, as well as the steering wheel inserts, and the door armrests. All from the same vendor, and they all match for color and finish. I'm very happy with the results, hope you will be too!
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top