Honda CR-V Owners Club Forums banner
Cancel
Create thread New Garage Forums
Status
Not open for further replies.

Driveshaft Mount Nut Broke Free

Jump to Latest
2.2K views 2 replies 2 participants last post by  JustinRRizzo  
J
#1 · (Edited)
One of the two (14mm?) bolts that hold the middle drive shaft mount on was a pain to get out.

On reinstall, it offered just as much resistance, and then popped the captive nut/rivet free.

Any ideas on how to fix this? Right now the driveshaft mount is only being held on by one nut.

I'm guess the nut on the inside is a rivet or a welded nut. Correct?

If it's a nut, I may cut out a small area so I can get a wrench on it.
 
#2 ·
You have enough posts for you to include pictures of your problem. Pics will help everyone here come to your aid. Also include your vehicle information by using your profile tab under your avatar. By doing so, every time you post a question, folks will know what year & model you have.

I believe that this YT video shows what your are referring to:

Might be a case where you have to take out the carpet & underlayment to see if the welded nut comes through the floor pan.

2015 Honda CR-V 5 Door LX (AWD) KA CVT Parts - HondaPartsNow.com

www.hondapartsnow.com www.hondapartsnow.com
 
J
#3 ·
This was my problem, and you can see the solution :) It was a welded sleeve in there, not a nut.

Unfortunately, it only solved 50% of my problem. One of the bushing/mounts for the diff was shot. Got them off, not I'm just trying to figure out how to press them back in.

Image
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Honda CR-V Owners Club Forums
posts
698K
members
207K
Since
2006
Honda CR-V Owners Club forum, the best hang-out to discuss CVT, Hybrids, trim levels and all things CR-V
Full Forum Listing
Explore Our Forums
Gen 5 CR-V: 2017-2022 (UK 2018-2023) Gen 4 CR-V: 2012-2016 (UK 2012-2018) Gen 3 CR-V: 2007-2011 (UK 2007-2012) Gen 2 CR-V: 2002-2006 (UK 2002-2007) Sat-Nav, Audio & Mobile Electronics