Honda CR-V Owners Club Forums banner
Status
Not open for further replies.

Bumper repair + reverse sensor

3.5K views 4 replies 3 participants last post by  K3lv  
#1 ·
Hi does any know a fix for a 2001 CRV rear bumper it's sagging at one corner ...not a lot but the panel gap is driving my crazy ..I can't find anything about rear bumpers online so no ideas what I'm looking for here . ...also has anyone successfully installed after market reverse sensors with any luck ? I have 2 light and an offset number plate in my bumper
 

Attachments

#2 ·
If i recall on older honda they snapped in ‘lips’ underneath.
Maybe pull the bumper and replace the clips and tighten all the brackets it attaches too

But for 15+ years that doesnt look that bad!
 
#3 ·
Yeah I heard it was clips thanks I'll have to pop it off and have a proper look ...it was perfect until a friend tried putting my exhaust center section on without jacking the car up and with the muffler on ...then got it stuck and tried prying it out

Thanks for the reply greatly appreciated
 
#4 ·
Do you by any chance have the same issue on the front bumper. I've got an irritating gap on mine. its been removed a few times so there is wear, but nothing is broken
 
Status
Not open for further replies.
You have insufficient privileges to reply here.