I just installed mine this past weekend. There is a slight gap to either side of the center attaching point. Can air flow through? seems unlikely but the gap is there.

 

NM CRV Newbie states:
Regarding the Tailgate Spoiler (which we don't have) will it help keep the rear window clean? In other words, does the air flow from the roof flow under the spoiler

In my experience road slush and rain on the back glass are slightly less intense than before spoiler installation. You will still need to use the rear wiper occasionally.

1ownerT states:
I just installed mine this past weekend. There is a slight gap to either side of the center attaching point. Can air flow through? seems unlikely but the gap is there.

My spoiler was installed by the dealer and there is no gap between the entire edge of the spoiler and the rear hatch. On your install some air might flow through, but I wouldn't be concerned about it.

 

NM CRV Newbie states:
Regarding the Tailgate Spoiler (which we don't have) will it help keep the rear window clean? In other words, does the air flow from the roof flow under the spoiler

In my experience road slush and rain on the back glass are slightly less intense than before spoiler installation. You will still need to use the rear wiper occasionally.

1ownerT states:
I just installed mine this past weekend. There is a slight gap to either side of the center attaching point. Can air flow through? seems unlikely but the gap is there.

My spoiler was installed by the dealer and there is no gap between the entire edge of the spoiler and the rear hatch. On your install some air might flow through, but I wouldn't be concerned about it.

You are absolutely 100% correct, I don't know what I was thinking
There is no gap on mine either.

 

I want one just cause it looks cool.

 

I have seen a few in the area with the spoiler. It looks GREAT!

 

P-chop experts?

Got an idea, since the rear hatch is tinted on the LX, how slick would a Black spoiler look instead of body color? (match the windows and clading) any photoshop pros here?! ... http://www.crvownersclub.com/forums/showthread.php?t=1644

 

Got an idea, since the rear hatch is tinted on the LX, how slick would a Black spoiler look instead of body color? (match the windows and clading) any photoshop pros here?! ... 2007 Taffeta White CR-V EX-L AWD - Honda CR-V Owners Club Forums

First post on CR-V Owners Club forums (although I used to post at the Element Owners Club forums a bit a couple years ago when I was thinking about getting one). Anyway, I'm no photoshop expert, but I'll be able to show you what this looks really looks like next week. I just picked up an 08 Taffeta White EX last night and ordered the Pearl Black spoiler for it earlier in the day. It's scheduled to be delivered Monday so I'll post some pics after I mount it.

Personally, I think it will look better than the body color units. The problem I have with them is that because the tail lights go all the way up to the top of the window, the body color spoilers end up looking like they're kind of hanging out there and tacked on. Especially since they don't match the roof rails they butt up to. I think with the black spoiler the roof rails will flow right into it, and since it's the shiny pearl black it should match the reflective privacy glass of the rear window pretty well too. Well, either that or I just wasted $220 .


ron

 

No success, so far...

I'm also interested in a black rear sun/dust deflector for my '07EX-L, rather than the Honda-brand and related Asian knock-offs. Here's the disappointing news:

I contacted EGR about availabilty. I received an email from EGR-USA indicating that they have no intention of producing one for the 07/08 CR-V. In fact, EGR is completely ending production of their rear sun/dust deflectors altogether.

I also emailed Lund and received a vague reply indicating that they don't have anything yet available for the current generation CR-V. No info on if/when one may become available...

 

The spoiler does not help or hurt the dirt collection on the back window . . . but it looks really cool, which is why I put one on my V. IMHO, the spoiler completes the back of the car - it looks finished now.

 

Black spoiler on Glacier Blue CR-V

There's somebody on this board that was going thinking about putting a Black Spoiler on a White CR-V. Did you ever do it? Can you post pictures.

I am thinking about putting a black spoiler on my Glacier Blue CR-V. I can get the part on Ebay for about $110.00 shipped. Then I can spray paint it myself for another $5.00. The reason is because Glacier Blue spray paint is hard to find, compared to black. I've seen a Lexus SUV that comes in all different colors, but the spoiler is always black.

 

Going for the cool factor myself, but sold my wife on the "less dirty" point, however even if it's the same, or slightly worse, she won't know and it still looks cooler.

 

Could I see a picture?

Please, please show me a picture of your CR-V with the spoiler.

thanks,
stan

 

Here's our CRV spoiler

Here is our CRV spoiler, right beside our Acadia spoiler.

 

i recently added the spoiler to the back of my 08 crv ex-l just for the looks. i don't think that the spoiler helps to keep back window from dirt but i've only had it for a couple of weeks.

 

Welcome To The Club!

R11, welcome to the club and neat idea on the contrasting spoiler. Do post photos of the results. If it works for you, I am going to get a white one for the Black Pearl! (Somehow I don't think it will work as well.)

Again welcome to the club, good luck with the new V, and we will be looking forward to see how your spoiler looks.

 

R11, welcome to the club and neat idea on the contrasting spoiler. Do post photos of the results. If it works for you, I am going to get a white one for the Black Pearl! (Somehow I don't think it will work as well.)

Again welcome to the club, good luck with the new V, and we will be looking forward to see how your spoiler looks.

Ah, but the theory is actually more of a Trim & Window Matching than Body Color Contrasting. As a NBP owner though you're covered either way! I am curious to see how it turns out. We shall see...



ron

 

Here's a few pics of the black spoiler. The light was starting to get a little low so there's not great detail but at least you can get an idea of how it looks on the vehicle.

 

And the rest:

ron

 

And the rest:

And a AP-2 Berlina....I'm the proud owner of a '08 Royal Blue Pearl CR-V EX and a '04 NFR AP-2. Hondas seem to run in families.

 

Looks very nice! Ties in with the roof rails, rear window, and lower cladding.

 

Yes! That definitely rocks. Looks alot like the Lexus RX black spoilers that someone mentioned in another thread. Not sure sure it would work with the Green Tea color, but it should give people more courage to take the leap after seeing yours. Thanks for the pics.

 

After having a little time to really look at it now I think it would look good with any of the CRV colors as long as they also had the privacy glass (or any similar aftermarket tinting). I think the glossy black spoiler would probably stick out and look out of place without the dark and reflective back window to sit on. With the privacy glass though it actually blends in and matches pretty darn well. I'm really happy and glad I went ahead with it now .


ron

 

I wasn't sure that was going to work but it looks really nice.

I have been contemplating a spoiler for my NBP.

How difficult was the install?

I looked at the instructions and it doesn't look too bad (except for the drill holes in my new car part)!

 

I agree, that black spoiler looks pretty cool.

But I agree with kipnita--I'm uncomfortable drilling holes in my Itachi-san.

I may get one in the next few months but maybe I'll attach it with the same adhesive Honda uses on the protective shipping film.

 

I would say that if you have any mechanical experience at all and have the tools, the install is straight forward and pretty simple. I drilled the outside holes with the hatch open using a little step ladder, and just wrapped a towel around under the hinges to catch the drilling bits and so I wouldn't have to worry about using a drill stop. Yes, it is a little disconcerting to start drilling holes in the roof of your vehicle. But if you carefully mark and lightly centerpunch for the holes, use sharp drill bits and just take your time, there's really no reason to worry. Many years ago I installed aftermarket sunroofs in a couple of my vehicles and compared to drilling a few holes, cutting out a large section of your roof with a jigsaw is a whole lot more freaky .

On the other hand, if you don't really have experience and/or the trepidation is a bit too much for you, I wouldn't think it should really cost much to have a dealer or any local mechanic you may know do the install instead. Sometimes peace of mind is well worth paying a little for too.


ron

 

I did mine today. Took me around 1.5 hours (I take my time). And installed the Body Side Moldings too. After that my car looks a lot better.


The follwing link is for Tailgate Spoiler Installation
YouTube - Episode #60 - Honda CR-V Tailgate Spoiler Installation

 

1.5 hours later.

View attachment 1302

View attachment 1303

View attachment 1304

 

is that modulo spoiler?
im still undecided whether i should get mugen $800Australian dollar or modulo $500Australian dollar $300 difference is alot of money

 

Nice work!


ron

 

Indeed, looks very sharp and nice.

I almost bought a Green Tea Metallic as I liked it better then the Glacier Blue my parents bought. But, I ended up with the gold (Borrego Beige Metallic) simply because I fell in love with the color once I saw it in person.

 

OK, one of my weekend projects is to install the spoiler.

I've received/inspected the spoiler - paint looks nice!

When I unpacked the spoiler I located the hardware but during my review of the instructions (for the upteenth time!) I noticed the rubber seals were missing.

Shook the box again, noting else fell out....looked in the box and a small "baggy" was taped to its interior. Suprise, rubber seals found!

I have reviewed the install instuctions and the video from College Hills multiple times.

Once I locate the correct tools (and overcome my fear of drilling into my car!) it looks like this can be done in 30-45 minutes.

I'll post next week re the project....

 

Shook the box again, noting else fell out....looked in the box and a small "baggy" was taped to its interior. Suprise, rubber seals found!


I'll post next week re the project....

Thanks for the post, kipnita. I'd looked 3 times for the gaskets. I read your post, and found a small piece of what looked like packing tape tightly taped to the inside of the box. I'm sure a lot of these get thrown away.